Fabbed and engine cradle/dolly that fits the socket on the floor jack. This will be handy since I'll probably have the engine in-out of the car 10-times while I build the roll cage.

I already knew the exhaust conflicts with the frame horn reinforcements installed earlier, but now you can see where it will need to be redone.

The engine is not in the car yet, but I had to take a picture just to goon out on what it will look like.

I didn't notice before, but the cheapo EMPI stinger isn't straight. It's no biggie since I'll had planned on cutting it off to install a muffler, but I'd be pissed if I wanted to run it as-is.